Staff Answer
Jul 09, 2026 - 09:06 AM
Yes, programming is required.
DIY programming instructions can be seen below:
https://www.carandtruckremotes.com/cd...
Programming Instructions Step by Step:
1. Locate the Data Link Port. It is located under dash drivers side.Be sure you know which pins are 8 and4.
2. Make sure there are metal contact pins in terminals 8 and4.Connect 8 to 4 with a suitable jumper wire (leave the jumperwire connected throughout the programming procedure).Make sure you know which terminals are 8 and4. The vehicle will respond by locking and unlocking the doors to signifyentering of programming mode.
3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. Afterabout 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.
4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.
5. Remove jumper wire applied to the OBDII Port.
DIY programming instructions can be seen below:
https://www.carandtruckremotes.com/cd...
How to Program a 2001 Chevrolet Tracker Key Fob, Keyless Entry Remote
Programming Instructions Step by Step:
1. Locate the Data Link Port. It is located under dash drivers side.Be sure you know which pins are 8 and4.
2. Make sure there are metal contact pins in terminals 8 and4.Connect 8 to 4 with a suitable jumper wire (leave the jumperwire connected throughout the programming procedure).Make sure you know which terminals are 8 and4. The vehicle will respond by locking and unlocking the doors to signifyentering of programming mode.
3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. Afterabout 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.
4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.
5. Remove jumper wire applied to the OBDII Port.
