Mercury remote keyless entry programming (sometimes called installation) and activation is a simple process. Actually, despite of the common name - remote programming, the process involves training the vehicle to recognize a new keyfob you purchased. This programming procedure should not take more then 1 minute if followed successfully. If it did not work or you missed a step, try programming your Mercury keyless entry unit again. You cannot brake anything.
MERCURY PROGRAMMING INSTRUCTIONS
1) Turn ignition from OFF to RUN (as far as you can go without cranking the engine) 8 times (one turn is from OFF to RUN and back to OFF) within 10 seconds, with the 8th time ending in RUN (8th time you only go from OFF to RUN and stop there) (do not start the engine).
2) All doors will lock then unlock to confirm programming mode.
3) Within 20 seconds, press any button on 1st car remote transmitter. Door locks will cycle to confirm remote programming.
4) Within 20 seconds, press any button on 2nd transmitter (up to 4 transmitters total possible). You have to press a button on every remote you have, including all the working original remotes if avail.
5) Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.
MERCURY REMOTE PROGRAMMING INSTRUCTIONS VIDEO BELOW
MERCURY MODELS
1999 2000 2001 2002 2003 2004 2005 2006 Mercury Sable
1999 2000 2001 2002 2003 Mercury Tracer
2005 2006 Mercury Mariner
2006 Mercury Milan
2005 2006 2007 Mercury Montego
2004 2005 2006 2007 Mercury Monterey minivan
1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 Mercury Mountaineer
2007 2008 2009 Mercury Grand Marquis
CLICK HERE TO SELECT YOUR VEHICLE