How to Program a 1995 Nissan Pathfinder Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
The Nissan system can learn up to four different remotes. If a fifth remote is entered the first remote is "bumped out" as only the last four to be entered are remembered. Anytimethe system is programmed allremotes to be used should be re-programmed to avoidunintentional "bumping"
1. Locate the electronic module. (Located under drivers seat on the right side.)
2. Under the center of the Nissan label on the top of the module there is a 7/8" hole. Rubyour finger overthe label to locate the hole. Punch through the label with your finger or a dull object suchas a pencileraser. Inside the hole is a square yellow button. This is theprogramming button.
3. Cycle the ignition key to ON then back to OFF. Press and hold the programming button.The siren will emitfour single introduction tones followed by a five tone burst. Release the programming button. The siren willnow emit single prompting tones at one secondintervals. Each prompting tone is an opportunity to program a remote. After any prompting tone press the large (arm/disarm) button of a remote. The siren will immediately emit a confirmation tone. Wait for another prompting tone and press the large button of another remote. Repeat until all transmitters to be used with the vehiclehave been learned.
4. Turn the ignition key ON the OFF to exit programming mode.
5. Test remotes and cover hole on top of electronic module with tape.
Use our Locksmith Search if you need professional help.