How to Program a 1995 Pontiac Bonneville Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:1. Insert key in ignition and leave in the OFF position
2. Locate theData Link Port. It is located under dash drivers side. Be sure you knowwhich pins are 8 and4.
(Note port is wider at top) YourOBDII port will not have numbers, use this diagramfor reference.
3. Make sure there are metal contact pins in terminals 8 and4. Connect 8 to 4 with a
suitablejumper wire (leave the jumper wireconnected throughout the programming
procedure). Makesure you know which terminals are 8 and4. The vehicle will respond
bylocking and unlocking thedoors to signify entering of programming mode.
4. Close doors.
5. Turn ignition to the ON position (asfar as you can go without cranking the engine).Doors will lock.
6. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to beprogrammed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors.Release the buttons on the transmitter.
7. Within one minute, repeat the previous step on the remaining transmitters to beprogrammed.
8. Remove jumper wire applied to the OBDII Port.
Use our Locksmith Search if you need professional help.