How to Program a 1996 Pontiac Firebird Keyless Entry Remote Fob
Programming Instructions Step by Step:1.Turn the ignition switch to the ON then OFF position.
2. Remove the RADIO fuse.
3. Cycle the ignition switch from the OFF position to the RUN position (as far as you can go withoutcranking the engine)3 times within 5 second ending in the RUN position. The vehicle will verifyentry into the programming mode by locking then unlocking the door locks.
4. Press and hold both the LOCK and UNLOCK buttons on the first transmitter for approximately15 seconds. The vehicle will verify programming by locking then unlocking the door locks. Your new remote has been accepted and all existing remote codes havebeen erased.
5.Repeat the previous step for each additional transmitter (including any existing transmitters).You may program up to 4 transmitters.This must be done before the RADIO fuse is reinstalled.
6. Place the ignition switch in the OFF position. IMPORTANT: The remote keyless entry systemwill not be operational if the radio fuse is open.
7. Replace the RADIO fuse. If at any time it is necessary to restart the procedure, turn the ignitionOFF and proceed again with step number1.
Use our Locksmith Search if you need professional help.