How to Program a 1997 Buick Riviera Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
1. Insert keys in ignition and leave in the OFF position.
2. Locate the OBDII Port.
.
(Note port is wider at top) Your OBDII port will not have numbers, use them for reference
3. Make sure there are metal contact pins in terminals 8 and4. Connect 8 and 4 with a suitablejumper wire (leave the jumper wire connected throughout the programming procedure). Makesure you know which terminals are 8 and4. The vehicle will respond by locking then unlocking thedoors to signify entering of programming mode.
4. Turn ignition to the ON position (as far as you can go without cranking the engine).
5. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to beprogrammed. Up to about 30 seconds, the vehicle will respond by locking then unlocking the doors. Release the buttons on the transmitter.
6. Within one minute, repeat the previous step on the remaining transmitter (if any including anyexisting remotes).
7. Remove jumper wire applied to the OBDII Port.
Use our Locksmith Search if you need professional help.