CLICK HERE TO SELECT YOUR VEHICLE

1997 Chrysler LHS Keyless Entry Remote Fob Programming Instructions

How to Program a 1997 Chrysler LHS Key Fob, Keyless Entry Remote, Smart Key



Programming Instructions Step by Step:

Method-1

97 service manual says to:

1 find data kink connector under steering column.

2 turn ignition on

3 ground pin 1 upper left most pin this is the programming line.

the door locks will lock then unlock.

4 press any key on the transmitter, locks will cycle to confirm

if you have a second transmitter press any button, wait for lock to cycle.

5 remove ground from pin 1

6 Done, test it outMethod-2Remove the bezel to the right of the steering wheel that has an a/c vent and the traction control switch (or not) and unplug (or find) the traction control connector. Place a jumper between pins 1 and 4 to place the receiver in teach mode. Operate the power door lock button on the door and push the lock/unlock button on the fob. If you have 2 fobs, do the 2nd one as well, it will remember2. Replace the connector and bezel.

Use our Locksmith Search if you need professional help.
Back to blog