CLICK HERE TO SELECT YOUR VEHICLE

1997 Pontiac Grand Am Keyless Entry Remote Fob Smart Key Programming Instructions

How to Program a 1997 Pontiac Grand Am Key Fob, Keyless Entry Remote, Smart Key

Programming Instructions Step by Step:

1.Make sure ignition is in the OFF position.

2. Locate the programming connector in the trunk (drivers side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access connector.

3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.

4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been accepted and all existing remotes have been erased.

5. Repeat the previous step for each additional remotes (including any existing remotes) Do not remove jumper wire in between programming of remotes.

6. Remove the jumper wire from the Keyless Remote Connector.

Use our Locksmith Search if you need professional help.
Back to blog