CLICK HERE TO SELECT YOUR VEHICLE

1998 Buick LeSabre Keyless Entry Remote Fob Smart Key Programming Instructions

How to Program a 1998 Buick LeSabre Key Fob, Keyless Entry Remote, Smart Key

Step by Step How to Program Instructions:

1. Insert key in ignition and leave in the OFF position.

2. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and4.

(Note port is wider at top) YourOBDII port will nothave numbers, use this diagramfor reference.

3. Make sure there are metal contact

pins in terminals 8 and4. Connect 8 to 4 with a suitable jumper wire

(leave connected throughout the programming procedure).

Make sure you know which terminals are 8 and4. The vehicle with

respond by locking and unlocking the doors to signify entering of

programming mode.4. Close doors.5. Turn ignition to the ON position (asfar as you can go without cranking the engine).Doors will lock.6.

Press and hold both the LOCK and UNLOCK buttons together on the first

remote to be programmed. After about 15 seconds, the vehicle will

respong by locking and unlocking doors. Release the buttons on remote.7. Within one minute, repeat previous step on the remaining remotes to be programmed.8. Remove jumper wire applied to the OBDII Port.



Use our Locksmith Search if you need professional help.
Back to blog