How to Program a 1998 Buick Skylark Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
1. Make sure ignition is in the OFF position.
2. Locate the Programming Connector in the trunk (driver's side). It is a plastic connector with twowires leading up to it. The connector is not plugged into anything. You may have to pull back trimto access the connector.
3. The programming connector should have two terminals. Connect both terminals with a suitablejumper wire. Make sure the terminals remain connected throughout the programming procedure.
4. Press the LOCK and UNLOCK buttons on the transmitter simultaneously. In response, theKeyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has beenaccepted and all existing remote codes have been erased.
5. Repeat the previous step for each additional transmitter (including any existing transmitters). Donot remove jumper wire in between programming of transmitters.
6. Remove the jumper wire from the Keyless Programming Connector.
Use our Locksmith Search if you need professional help.