CLICK HERE TO SELECT YOUR VEHICLE

1998 Toyota 4Runner Keyless Entry Remote Fob Programming Instructions

Programming Instructions for 1998 Toyota 4Runner Remote Fob

Do-It-Yourself programming procedure is not available for this vehicle. This vehicle requires a diagnostic equipment to be connected to the vehicle to program the remote. You will need to find a local automotive locksmith or a dealer to program this remote.

Key Programming Information for 1998 Toyota 4Runner

Have your master Toyota key at hand (black key)

1. Insert black programmed key into ignition.
2. Press and release accelerator pedal 5 times within 15 seconds of inserting key into ignition.
3. Press and release brake pedal 6 times within 20 seconds of step 2.
4. Remove black key from ignition switch.
5. Insert new unprogrammed key into ignition within 10 seconds of step 4.
6. Press and release accelerator pedal once within 10 seconds of step 5.
7. Once these steps are performed properly you will see the immobilizer warning lamp begin to flash and after one
minute the lamp will stop flashing. Once the immobilizer warning lamp stops flashing you will have ten seconds to insert an additional key to be programmed.
8. Within ten seconds of inserting key into ignition press and release accelerator pedal once.
9. Immobilizer warning lamp will flash and after one minute the lamp will shut off.


Use our Locksmith Search for professional help.
Use our Program Instruction Search for programming instructions.
Back to blog