How to Program a 1999 Chevrolet Venture Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
1. Removekey from ignition.
2. Remove the BCM PRGRM fuse from the fuse panel, accessed by opening the front passenger door. Use the legend on the fuse panel to properly locate the BCMPRGRM fuse.
3. Close all of the doors.
4. Close the liftgate.
5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you the opposite direction from starting the engine).
6. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
7. Open and close any vehicle door. A chime will be heard when the system enters the programming mode.
8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.IMPORTANT: After 7 seconds, a chime may be heard confirming successful synchronization. Itis necessary to wait approximately 14 seconds for a second chime that will confirm successfulprogramming. Your new remote has been accepted and all existing remote codes have been erased.
9. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters).
10. Remove the ignition key from the ignition lock cylinder.
11. Install the BCM PRGRM fuse back into the fuse panel.Can I Program an ignition key for this vehicle?
Use our Locksmith Search if you need professional help.