CLICK HERE TO SELECT YOUR VEHICLE

1999 GMC Sierra Keyless Entry Remote Fob Programming Instructions

How to Program a 1999 GMC Sierra Keyless Entry Remote Fob

Programming Instructions Step by Step:

Use this procedure for New Body Style.1. Close all doors

2. Insert key into ignition

3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down untilinstructed to release in step9.

4. Perform steps 5 through 8 in a fairly rapid succession.

5. Turn the ignition to the ON position (as far as you can go without starting the engine.)

6. Turn the ignition to the OFF position.

7. Turn the ignition to the ON position (as far as you can go without starting the engine.)

8. Turn the ignition to the OFF position.

9. Release the power UNLOCK button on the door panel. The vehicle should respond by door locks locking and unlocking automatically. (If locks do not cycle after you let go, not before you let go of the unlock button, then the vehiclehas not entered programming mode and you must start procedure over. Remove key from ignition, open drivers door and return to step 1 ). If the locks do cycle automatically then proceed to step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).

12. Turn the ignition to the ON position to exit the programming mode.

13. Test remote(s).

Use this procedure for the Old Body Style (The video below will not work for the Old Body Style)

1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and4.

(Notice port is wider on top row)



2. Make sure there are metal contact pins in terminals 8 and4. Connect 8 to 4 with a suitable jumper wire leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.

3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.

4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.

5. Remove jumper wire applied to the OBDII Port.

Use our Locksmith Search if you need professional help.
Back to blog