How to Program a 1999 Honda Odyssey Keyless Entry Remote Fob
Programming Instructions Step by Step:1999 EX Model with Factory Installed Keyless Entry System.
1999 EX Model with Dealer Installed Keyless Entry System.
Note:This system will accept up to three remotes. The remotes are stored in a stacking-type memory. If a fourth remote is programmed the first remotewill be erased.
1. Turn ignition switch to ON (II)
2. Within 4 seconds press the LOCK or UNLOCK button on one of the remotes.Make sure remote is aimed at the receiver near the glove box.
3. Within 4 seconds turn ignition switch to LOCK (0)
4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step2.
5. Within 4 seconds turn the ignition switch to ON (II).
6. Within 4 seconds press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirmyou are in programming mode.Press the LOCK or UNLOCK button again.
7. Press the LOCK or UNLOCK button on each remote you want to program. Makesure door locks cycle after youpush each remote button to confirm system hasaccepted the remote.
8. Turn the ignition switch to LOCK (0) to exit programming mode.
9. Test remote(s)
1999 LX Model with Dealer Installed Keyless Entry System.
1. Turn ignition switch to ON (II)
2. Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed remote can be used for this step).
3. Turn ignition switch to LOCK (0)
4. Repeat steps 1, 2 and 3 two more times using the same keyless remote usedin step 2
5. Turn the ignition switch to ON (II)
6. Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirmyou are in programming mode.
7. Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after youpush each remote button to confirm system has accepted the remote.
8. Turn the ignition switch to LOCK (0) to exit programming mode.
9. Test remote(s)
Use our Locksmith Search if you need professional help.