How to Program a 2000Chevrolet Silverado Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver's door panel-continue to hold down until instructed to release in step9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.
Use this procedure for Classic body style.
1.Locate theData Link Port. It is located under dash drivers side.Be sure youknow which pins are8 and4.
(Notice port iswider on top row)
2. Make sure there are metal contact pins in terminals 8 and4.Connect 8 to 4 with a suitable
jumper wire (leave the jumper wire connected throughout the programming procedure). Make s
ure you know which terminals are 8 and4. The vehicle will respond by locking and unlocking the
doors to signifyentering of programming mode.
3. Press and hold both the LOCK and UNLOCK buttonstogether on the first transmitter to beprogrammed. After about15 seconds, the vehicle will respond by locking and unlocking thedoors.Release the buttons on the transmitter.
4. Within one minute, repeat the previous step on the remainingtransmitters to be programmed.
5. Remove jumper wire applied to the OBDII Port.
Use our Locksmith Search if you need professional help.