How to Program a 2001 Nissan Xterra Key Fob, Keyless Entry Remote, Smart Key
Step by Step How to Program Instructions:
IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.
1. Close and lock all doors with the driver's side power lock/unlock switch.
2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your HazardLamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylindereach time. If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not pressthe button more than one time in the above step. If the button is pressed more than one time, the programmingprocedure will not be successful.
5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver's sidepower lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps shouldflash. Repeat this step for each transmitter (including any existing transmitters).
6. Turn the key to the OFF position, remove the keys from the ignition. Then unlock doors using the driver's side power lock/unlock and open the driver's side door.
Use our Locksmith Search if you need professional help.