How to Program a 2002 Honda Odyssey Keyless Entry Remote Fob
Step by Step Programming Instructions:2002 EX Model with Factory Installed Keyless Entry System.
Note:
This system will accept up to three remotes. The remotes are stored in astacking-type memory. If a fourth remote is programmed the first remotewill be erased.
1. Turn ignition switch to ON (II)
2. Within 4 seconds press the LOCK or UNLOCK button on one of the remotes.
Make sure remote is aimed at the receiver near the glove box.
3. Within 4 seconds turn ignition switch to LOCK (0)
4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
in step 2
5. Within 4 seconds turn the ignition switch to ON (II)
6. Within 4 seconds press the LOCK or UNLOCK button the same remote. Make
sure the power door locks cycle to confirmyou are in programming mode.
Press the LOCK or UNLOCK button again.
7. Press the LOCK or UNLOCK button on each remote you want to program. Make
sure door locks cycle after youpush each remote button to confirm system has
accepted the remote.
8. Turn the ignition switch to LOCK (0) to exit programming mode.
9. Test remote(s)
2002 LX Model with Dealer Installed Keyless Entry System.
1. Turn ignition switch to ON (II)
2. Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed
remote can be used for this step.)
3. Turn ignition switch to LOCK (0)
4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
in step 2
5. Turn the ignition switch to ON (II)
6. Press the LOCK or UNLOCK button the same remote. Make sure the power door
locks cycle to confirmyou are in programming mode.
7. Press the LOCK or UNLOCK button on each remote you want to program. Make
sure door locks cycle after youpush each remote button to confirm system has
accepted the remote.
8. Turn the ignition switch to LOCK (0) to exit programming mode.
9. Test remote(s)
Use our Locksmith Search if you need professional help.