CLICK HERE TO SELECT YOUR VEHICLE

2006 Jeep Wrangler Keyless Entry Remote Fob Programming Instructions


Programming Instructions for 2006 Jeep Wrangler:

Please Note: This vehicle requires the Vehicle Remote to be programmed by a qualified professional.
This requires that a Locksmith use specialized computer equipment to program your vehicle remote.

Helpful Instructions:

  • Find a qualified Locksmith to program your vehicile with our Locksmith Locator

  • If your vehicle is unlockable and drivable, save money by driving to one of the Locksmiths you found in our Locksmith Search.

  • OR

  • Arrange with one of the locksmiths to visit you onsite.


  • Locksmith Search

    Key Programming Information for 2006 Jeep Wrangler

    Have all keys for the Dodge/Chrysler/Jeep ready - You must have two working programmed or original keys to use this procedure
    *** 2010+ VEHICLES MUST BE PROGRAMMED BY AN AUTOMOTIVE LOCKSMITH OR DEALER ***
    ***If ignition recall was performed on your vehicle, the DIY programming won't be available***
    ATTENTION DODGE RAM OWNERS: Some 2009 and up DODGE RAM'S may require dealer programming. If you have a 2009 DODGE RAM, please contact your local dealership to see if your vehicle requires dealer programming.

    1. Insert first programmed key into the ignition and turn ignition switch to ON. Wait for approximately 3 seconds then turnignition to OFF and remove key.
    2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON. Waitapproximately 10 seconds. You will see the immobilizer warning lamp illuminate on the dash and you will hear an audible tone.Turn ignition OFF and remove the key.
    3. Within 50 seconds insert the new unprogrammed key into ignition. Turn ignition switch to ON. After approximately 10 secondsyou should hear an audible tone and the immobilizer lamp will remain illuminated for 3 seconds. Once this occurs programming iscompleted.
    4. For each additional key you must repeat these steps starting with step number 1.
    Back to blog