CLICK HERE TO SELECT YOUR VEHICLE

2007 Chevrolet Silverado Keyless Entry Remote Key Fob Programming Instructions

How to Program a 2007 Chevrolet Silverado Key Fob, Keyless Entry Remote, Smart Key

Programming Instructions Step by Step:2007 Old Body Style Programming Instructions

1. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver's door panel continue to hold down until instructed to release in step9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.

11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

2007 New Body Style Programming Instructions

Use this Procedure for Vehicles with Driver Information Center Buttons

1.Insert Key and turn to ONposition so you can access Driver Information Center

2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays

3. Press the set/reset button untilREMOTE KEY LEARNING ACTIVE displays4. Press and hold the lock and unlock buttons on the keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.5. To program additional remotes at this time repeat step4. This vehicle can have a maximum of eight remotes programmed.6. To exit programming mode turn key off and remove key. Test remote(s).

Use this Procedure for Vehicleswithout Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine).

1. Press the trip odometer reset stem untilRELEARN REMOTE KEY displays.

2. Press and hold the trip odometer reset stem for threeseconds. The message REMOTE KEY LEARNING ACTIVE will display.3. Press and hold the lock and unlock buttons on the first keyless remote at the sametimefor approximately 15 seconds. A chime will sound indicating that the remote isprogrammed.4. To program additional remotes at this time repeat step3.This vehicle can have a maximum of eight remotes programmed.5. To exit programming mode turn key off and remove key. Test remotes.





Use our Locksmith Search if you need professional help.
Back to blog