How to Program a 2007 GMC Sierra Keyless Entry Remote Fob
Programming Instructions Step by Step:2007 Old Body Style1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down until instructed to release in step9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by door locks locking and unlocking automatically. (If locks do not cycle after you let go,not before you let go of the unlock button, then the vehicle has not entered programming mode and you must start procedure over. Remove key from ignition, open drivers door and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
2007 New Body Style
Use this Procedure for Vehicles with
Driver Information Center Buttons
This information is in your Owners Manualin the DriversInformation Center Section.
1.Insert Key and turn to ONposition so you can access Driver Information Center
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the keyless remote at the same time forapproximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step4. This vehicle can have a maximum ofeight remotes programmed
6. To exit programming mode turn key off and remove key. Test remote(s).
Use this Procedure for Vehicleswithout
Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in theon position (as far as you can go without cranking engine)
1. Press the trip odometer reset stem untilRELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for threeseconds. The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first keyless remote at the same timefor approximately 15 seconds. A chime will sound indicating that the remote is programmed.
4. To program additional remotes at this time repeat step3. This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key. Test remote(s).
Use our Locksmith Search if you need professional help.