CLICK HERE TO SELECT YOUR VEHICLE

2009 Toyota Tundra Keyless Entry Remote Fob Smart Key Programming Instructions

How to Program a 2009 Toyota Tundra Key Fob, Keyless Entry Remote, Smart Key



Programming Instructions Step by Step:

1. Start with the key out of the ignition,drivers door is open all others closed anddrivers door is unlocked.

2. Perform these steps within 5 seconds.

A. Insert the key into the ignition(Do NOT Turn) Pull key out.

B. Insert the key into the ignition(Do NOT Turn) Pull key out.

3. Perform these steps within40 seconds.

A. Close then open the drivers door.

B. Close then open the drivers door.

C. Insert the key into the ignition(Do NOT Turn) Pull key out.

4. Perform these steps within40 seconds.

A. Close then open the drivers door.

B. Close then open the drivers door.

C. Insert the key into ignition and leave it in ignition.

D. Close the drivers door.

E. Turn the ignition to ON (Do NOT Start) then back to OFF.

F. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should lock then unlock automaticallyindicating successful entry into programming mode.Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within40 seconds.

A. Press the lock and unlock buttons on the remote simultaneously for1.5 seconds.

B. Immediately after letting go of the lock and unlock buttons,Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step6 as the remote was not accepted.

C. Repeat steps A and B in step 6 for each new remote.

7. Open drivers door.



Alternative Procedure

1. Start with key out of ignition, drivers door is open all others closed anddrivers door is unlocked.

2. Insert key into the ignition and pull out. Do not turn or start vehicle. Just put key in and pull out..

3. Perform these steps within 40 seconds.

A. Using the power lock switch on the drivers door, perform 5 lock/unlock cyclesstarting with lock. Use an even pace and try to go about one cycle per second.(1 Cycle = 1 lock and 1 unlock).

B. Close the drivers door, then open the drivers door.

4. Perform these steps within 40 seconds.

A. Using the power lock switch on the drivers door, perform 5 lock/unlock cyclesstarting with lock. Use an even pace and try to go about one cycle per second.(1 Cycle = 1 lock and 1 unlock).

B. Insert the key in the ignition cylinder.

C. Turn the ignition to ON (Do NOT Start) then back to OFF.

D. Remove the key from the ignition.

5. Within 3 seconds the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.

A. Press the lock and unlock buttons on the remote simultaneously for 1 second.

B. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle onceindicating successful programming. If the door locks do not cycle, or cycle twice. Repeat steps A and B in step 6 as your remote has not been accepted.

C. Repeat steps A and B in step 6 for each new remote.

7. Close drivers door.Can I Program an Ignition Key?

Use our Locksmith Search if you need professional help.
Back to blog