How to Program a 2010 Chevrolet Silverado Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:Use this Procedure for Vehicles with Driver Information Center Buttons1.Insert Key and turn to ONposition so you can access Driver Information Center
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button untilREMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step4. This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove key. Test remote(s).
Programming Instructions Step by Step:
Use this Procedure for Vehicleswithout Drivers Information Center ButtonsTo access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine).
1. Press the trip odometer reset stem untilRELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for threeseconds. The message REMOTE KEY LEARNING ACTIVE will display.
3. Press and hold the lock and unlock buttons on the first keyless remote at the sametimefor approximately 15 seconds. A chime will sound indicating that the remote isprogrammed.
4. To program additional remotes at this time repeat step3.This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key. Test remotes.
Use our Locksmith Search if you need professional help.