CLICK HERE TO SELECT YOUR VEHICLE

2010 Honda Element Keyless Entry Remote Fob Programming Instructions


Programming Instructions for 2010 Honda Element Remote Fob

Entering the programming mode cancels all learned keyless remotes, so none of the previously programmed remotes willwork.

You must reprogram all of the keyless remotes once you are in the programming mode. You must complete each step within 5 seconds of the previous step to keep the system from exiting the programmingmode.

1. Turn ignition switch to ON (II)
2. Press the LOCK or UNOCK button on one of the remotes. (An unprogrammed remote can be used for this step.)
3. Turn ignition switch to LOCK (0)
4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step 2
5. Turn the ignition switch to ON (II)
6. Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirm you are inprogramming mode.
7. Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you pusheach remote button to confirm system has accepted the remote.
8. Turn the ignition switch to LOCK (0) to exit programming mode.
9. Test remote(s)

Key Programming Information for 2010 Honda Element

Do-It-Yourself programming procedure is not available for this vehicle. This vehicle requires a diagnostic equipment to be connected to the vehicle to program the key. You will need to find a local automotive locksmith or a dealer to program this key.

Use our Locksmith Search if you need professional help.
Back to blog