How to Program a 2011 Jeep Liberty Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
Note: You must have two programmed keys to add a new key to the system.
1. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds.Then, Turn the ignition switch to the LOCK position and remove the first key.
2. Insert the second valid key into the ignition switch. Turn the ignition switch tothe ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switchto the LOCK position and remove the second key.
3. Insert the new key into the ignition switch. Turn the ignition switch to theON/RUN position. within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate thatprogramming is complete, the Vehicle Security Light will turn on again for seconds and then turn off.
The new key is now programmed.
The Remote Keyless Entry transmitter willalso be programmed during this procedure.
Repeat this procedure to program up to eight keys.
**If you only have ONE WORKING REMOTE/KEY and want to add a second key, Click Here to Buy Programmer.
**If you have no working keys. Click Here to Locate A Locksmith in your area.
Use our Locksmith Search if you need professional help.