CLICK HERE TO SELECT YOUR VEHICLE

2014 Mazda 3 Keyless Entry Remote Fob Smart Key Programming Instructions

Programming Instructions for 2014 Mazda 3:

Please Note: This vehicle requires the Vehicle Remote to be programmed by a qualified professional.
This requires that a Locksmith use specialized computer equipment to program your vehicle remote.

Helpful Instructions:

  • Find a qualified Locksmith to program your vehicile with our Locksmith Locator

  • If your vehicle is unlockable and drivable, save money by driving to one of the Locksmiths you found in our Locksmith Search.

    • OR

  • Arrange with one of the locksmiths to visit you onsite.


    • Locksmith Search

    Key Programming Information for 2014 Mazda 3

    You must have 2 original keys that start your engine to perform this procedure. If you only have one working key or none at all it must be programmed by a dealer or locksmith! Your New third (unprogrammed) key must also be cut prior to performing this procedure.
    Please Note: If one of your keys is a cloned key from a hardware store this procedure will NOT work. This procedure requires original programmed keys.

    1. Insert an existing (working) key into the ignition cylinder.
    2. Turn the ignition cylinder ON (just shy of starting the car Without cranking the engine) and back to OFF. Ignition should stay in ON position for approximately 3 seconds until security extinguishes.
    3. Turn to OFF positing and remove the existing key
    4. WITHIN TEN SECONDS, insert a second working key and turn to ON and then back to OFF. Ignition must be on for at least 3 seconds until security light extinguishes.
    5. Turn to OFF positing and remove the existing key.
    6. Insert the New (unprogrammed) key before twenty seconds have elapsed and turn to ON. Leave it in the ON position for at least 3 seconds and turn back to OFF.
    7. The security light will light up for THREE seconds to indicate the new key has been successfully programmed.
    For those who do not have 2 original keys: These keys can NOT be cloned at hardware stores like Ace, Lowes, Walmart, & Home Depot. They must be programmed by an automotive locksmith or dealership.
    Back to blog