How to Program a 2015 Ford Transit Key Fob, Keyless Entry Remote, Smart Key
Step by Step How to Program Instructions:
You must have two previously programmed keys and the new unprogrammed key readily accessible. If you do not have two previously programmed keys you will need a Locksmith to cut and program a second key.
1. Insert the first previously programmed key into the ignition.
2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
3. Switch the ignition off and remove the first programmed key from the ignition.
4. After three seconds but within 10 seconds of switching the ignition off, insert the second previously programmed key into the ignition.
5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
6. Switch the ignition off and remove the second previously programmed key from the ignition.
7. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
9. Remove the newly programmed key from the ignition. If the key has been successfully
programmed it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait 10 seconds and repeat Steps 1 through8.If you have a separate key and remote use this procedure to program the remote.1. Open driver's door.2. Get in and put seat belt on.3. Close driver's door.4. Turn ignition ON (Do not start just to on position.) and OFF 4 times.5. Door locks with cycle one time.6. Press any button on remote 2 times.7. Locks will cycle.8. Remove key, take seat belt off and get out of vehicle.9. Test remotes.
Use our Locksmith Search if you need professional help.