Programming Instructions for 2015 Jeep Wrangler Remote Fob
Have all keys for the Dodge/Chrysler/Jeep ready - You must have two working programmed or original keys to use this procedure.Your new keys must be cut prior to performing this procedure.
Remote portion and immobilizer are programmed during the same programming procedure.
Please Note: this programming procedure WILL NOT WORK if your vehicle has PUSH BUTTON ignition.
1. Insert first programmed key into the ignition and turn ignition switch to ON. Wait for approximately 3 seconds then turn ignition to OFF and remove key.
2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON. Wait approximately 10 seconds. You will see the immobilizer warning lamp illuminate on the dash and you will hear an audible tone.Turn ignition OFF and remove the key.
3. Within 50 seconds insert the new unprogrammed key into ignition. Turn ignition switch to ON. After approximately 10 secondsyou should hear an audible tone and the immobilizer lamp will remain illuminated for 3 seconds. Once this occurs programming iscompleted.
4. For each additional key you must repeat these steps starting with step number 1.
Key Programming Information for 2015 Jeep Wrangler
Have all keys for the Dodge/Chrysler/Jeep ready - You must have two working programmed or original keys to use this procedure.Your new keys must be cut prior to performing this procedure.
Remote portion and immobilizer are programmed during the same programming procedure.
Please Note: this programming procedure WILL NOT WORK if your vehicle has PUSH BUTTON ignition.
1. Insert first programmed key into the ignition and turn ignition switch to ON. Wait for approximately 3 seconds then turn ignition to OFF and remove key.
2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON. Wait approximately 10 seconds. You will see the immobilizer warning lamp illuminate on the dash and you will hear an audible tone.Turn ignition OFF and remove the key.
3. Within 50 seconds insert the new unprogrammed key into ignition. Turn ignition switch to ON. After approximately 10 secondsyou should hear an audible tone and the immobilizer lamp will remain illuminated for 3 seconds. Once this occurs programming iscompleted.
4. For each additional key you must repeat these steps starting with step number 1.
Use our Locksmith Search if you need professional help.