CLICK HERE TO SELECT YOUR VEHICLE

2016 Lincoln MKC Keyless Entry Remote Fob Smart Key Programming Instructions

Programming Instructions for 2016 Lincoln MKC:

Please Note: This vehicle requires the Vehicle Remote to be programmed by a qualified professional.
This requires that a Locksmith use specialized computer equipment to program your vehicle remote.

Helpful Instructions:

  • Find a qualified Locksmith to program your vehicile with our Locksmith Locator

  • If your vehicle is unlockable and drivable, save money by driving to one of the Locksmiths you found in our Locksmith Search.

    • OR

  • Arrange with one of the locksmiths to visit you onsite.


    • Locksmith Search

    Key Programming Information for 2016 Lincoln MKC


    Please Note: A maximum of 4 smart keys can be programmed to your vehicle.
    ADDING SPARE SMART KEYS:
    You must have 2 already programmed and working smart keys inside the vehicle and the new un-programmed keys. If you don't have two previously programmed keys, you would need to take your vehicle to your authorized dealer or an automotive locksmith to have the spare key(s) programmed.
    BEFORE YOU BEGIN PROGRAMMING PROCEDURE:
    Ensure that the vehicle engine is off. Ensure that all doors are closed. Make sure that all doors remain closed throughout the procedure. You must have both working keys with you during the programming procedure.
    Follow the steps exactly as described below, you will have 30 seconds to complete it. If any steps are performed out of sequence, stop and wait at least one minute before starting again.
    Please read and understand the entire procedure before you begin.

    1. Place existing programmed smart key, in the backup slot in the center console. The key ring must be at the top with the buttons facing toward the rear.
    2. Wait 5 seconds, and then press the START/STOP button without starting the engine.
    3. Remove existing programmed smart key from the backup slot.
    4. Within 10 seconds, place a second programmed smart key in the backup slot and
    press the START/STOP button without starting the engine.
    5. Wait 5 seconds, and then press the START/STOP button again without starting the engine.
    6. Remove second programmed smart key from the backup slot.
    7. Wait 5 seconds, then place new unprogrammed smart key in the backup slot and
    press the START/STOP button again without starting the engine.
    Programming is now complete.
    8. Repeat steps 6-7 if you have another new unprogrammed key.

    Please Note: You can only have a maximum of four smart keys programmed to your vehicle.
    If programming was not successful, wait 10 seconds and repeat Steps 1 through 7.
    Back to blog