How to Program a 2023 Buick Enclave Key Fob, Keyless Entry Remote, Smart Key
Step by Step How to Program Instructions:Use this procedure to add a remote to the systemA new remote key can be programmed to the vehicle when have two already programmed remote keys. To program, the vehicle must be off and all of the remote keys, both currently recognized and new, must be with you.1. Press the button on the side of the remote key near the bottom and pull the key out. Never pull the key out without pressing the button.2. Place the two recognized remote keys in the cupholder.3. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the new remote key into the key lock cylinder on the driver door handle and turn the key, counterclockwise, to the unlock position five times within 10 seconds. The DIC displays READY FOR REMOTE #3, 4, 5, etc.4. Remove the top tray and the rubber mat inside the center console storage area. Place the new remote key into the remote key pocket.5. Press ENGINE START/STOP. When the remote key is learned the DIC display will show that it is ready to program the next remote key.6. Remove the remote key from the remote key pocket and press the remote key LOCK or UNLOCK button. To program additional remote keys, repeat Steps 35. When all additional remote keys are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.7. Put the key back into the remote key.8. Replace the key lock cylinder cap.Use this procedure when you have no working remotes.If two currently recognized remote keys are not available, follow this procedure to program up to eight remote keys. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the remote keys you wish to program must be with you.1. Press the button on the side of the remote key near the bottom and pull the key out. Never pull the key out without pressing the button.2. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the remote key into the key lock cylinder on the driver door handle and turn the key, counterclockwise, to the unlock position five times within 10 seconds. The DIC displays REMOTE LEARN PENDING, PLEASE WAIT.3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press ENGINE START/STOP. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.4. Repeat Step 2 two additional times. After the third time all previously known remote keys will no longer work with the vehicle. Remaining remote keys can be relearned during the next steps. The DIC display should now show READY FOR REMOTE #1.5. Remove the top tray and the rubber mat inside the center console storage area. Place the new remote key into the remote key pocket.6. Press ENGINE START/STOP. When the remote key is learned the DIC display will show that it is ready to program the next remote key.7. Remove the remote key from the remote key pocket and press the remote key LOCK or UNLOCK button. To program additional remote keys, repeat Steps 46. When all additional remote keys are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.8. Put the key back into the remote key.9. Replace the key lock cylinder cap.
Use our Locksmith Search if you need professional help.