How to Program a 2023 Chevrolet Camaro Key Fob, Keyless Entry Remote, Smart Key
Programming Instructions Step by Step:
A new transmitter can be programmed to the vehicle when there are two recognized transmitter. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be with you.
1. Place the two recognized transmitters in the rear cup holder in the center console.
2. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the new transmitter into the key lock cylinder on the driver door handle and turn the key to the unlock position five times within 10 seconds.
The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5, 6,7, or 8
3. Replace the recognized transmitter with a new transmitter. Place the new transmitter in the rear cupholder in the center console.
4. Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that
it is ready to program the next transmitter.
5. Remove the transmitter from the transmitter pocket and press Lock or Unlock.
To program additional transmitters, repeat Steps 3 thru5. When all additional transmitters are programmed press and hold, ENGINE START/STOP for twelve seconds to exit programming mode.
6. Put the key back in the transmitter.
If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure
will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters to be programmed must be with you.
1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key to the
unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press ENGINE START/STOP. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
3. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps.The DIC display should now show READY FOR REMOTE #1.
4. Place the new transmitter into the rear cupholder in the center console.
5. Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that
it is ready to program the next transmitter.
6. Remove the transmitter from the cupholder and press Lock or Unlock. To program additional transmitters, repeat Steps 4 thru6.
7. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
Use our Locksmith Search if you need professional help.